Velodyne SC-600 IFC - INSTALLATION REV A User Manual download pdf (Page 11)

www.velodyne.com

Optimum User’s Manual

ollowing are brief descriptions of the connections described in Figure 2. More detail on these

connections can be found in the next section.

(1) LOW-PASS CROSSOVER

Use this knob to select the frequency above which you wish to roll off the signal to the

subwoofer. When the knob is turned all the way to the left, the Subwoofer Direct feature

is invoked and the subwoofer plays all frequencies up to 200 Hz.

(2) VOLUME Control

This control allows you to balance the output from the subwoofer to the main speakers in

your system. This control should be set to achieve similar volume level from between both

the main speakers and subwoofer. When pressing volume up or down, set the level while

watching the LED display for reference. The upper button increases the subwoofer level and

the lower button decreases it.

Note: Volume is also controllable by using the supplied remote. When defaults are restored,

the default volume setting is 30 out of 80.

(3) AUTO ON/OFF Switch

Use this switch to select between auto-on (active) and constant on (auto-on

inactive) operation.

(4)

LINE OUTPUT

Connect these jacks to the LINE IN amp input to use the Optimum subwoofer’s internal high

pass crossover. See below for a more detailed explanation of this crossover.

(5) LINE INPUT/LFE Input

Connect these jacks to the LINE OUT pr

eamp output, LFE output or subwoofer output jacks

of your receiver/processor. If using the LFE output from your receiver or processor, plug

the single cable into the “L” - LFE input or for more signal, use a “Y” connector (not included)

and feed the signal into both “R” and “L” inputs.

(6) SPEAKER LEVEL INPUT Terminals

Connect these input terminals to the speaker output terminals of your amplifier or receiver.

If you use this method of connection, when you go to the receiver speaker set up menu,

make sure you select the large speaker option.

(7) IR Input

This is a connection that allows the utlization of a thir

d par

ty infrar

ed r

emote sensor

, such

as Elan or Xantech, or an extended cable for placement closer to your other remote

contr

olled equipment. This keeps you fr

om awkward control angles using the infrared

emote control.

(8) 12v Trigger

When this 2-conductor mini jack is connected, the amplifier remains in power-off mode until

the trigger is applied. The correct trigger is +12V on the tip of the connector relative to the

grounded sleeve.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Comments to this Manuals

No comments

Velodyne SC-600 IFC - INSTALLATION REV A User Manual Page 11

Comments to this Manuals

Related products and manuals for Soundbar speakers Velodyne SC-600 IFC - INSTALLATION REV A