Interconnect cables
When installing your VA-806/907 using the line-level inputs/out-
puts, you should use standard shielded phono cables. Always keep
the lines as short as practical to minimize noise.
When using the speaker-level inputs/outputs, use the same quality
speaker cable to your subwoofer as you run to your satellites.
Placement
The VA-806/907 operates at very low frequencies which are prima-
rily non-directional. While it is recommended that the subwoofer be
placed on the same plane as the satellite speakers, room and
system conditions often dictate otherwise. See your dealer for help
in placement.
7
☞
4
☞
150 hz. The subwoofer's response will begin rolling off above the
frequency you set this control to.
You should set the crossover frequency to obtain a smooth and
seamless transition from the subwoofer to the main speakers in
your system. If your main speakers are smaller units with limited low
frequency output, you may wish to choose a higher frequency (such
as 100-120hz) than you would with larger speakers which have
greater low frequency output. With larger speakers, you might start
with this control set lower, such as 80hz.
Phase adjustment
This control allows you the ability to compensate for having the
subwoofer in a different location than the main speakers. Ideally,
you will have the sound from the subwoofer reach the listening
position the same time as the sound from the main speakers.
However, if the distance from the listening position to the subwoofer
and the distance from listening position to the main speakers differs,
the sound from each will reach your ears at a different time.
This control allows the signal to be delayed 180 degrees so the
output of the subwoofer will blend in to that of your main speakers
without any cancellation.
Auto turn on switch
The auto turn on switch allows the user to bypass the auto turn on
function if desired. When set in the "auto" mode with main power on,
the VA-806/907 will turn itself on when an input signal is present. If
no signal is present, after several minutes the unit will shut itself off.
When set in the "on" mode, the auto turn on/off function is bypassed
and the unit will be on whenever the main power switch is on.
Power switch
The master power switch is located on the right half of the unit. This
slide style switch is the main on/off for the unit. This switch should
be set to up for on , down for off.
continued. . .
INTEGRATED AMP / RECEIVER
SATELLITE SPEAKERS
Figure 2: Installation using speaker-level (from amplifier) inputs
WARNING:
AVIS:
CAUTION!
CAUTION!CAUTION!CAUTION!CAUTION!
FREQUENCY
VOLUME
PHASE
+ R - - L +
MAIN OUTPUTS
(speaker-level)
+ -
+ -
(6 pages)
(17 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals